User's Manual

5 PRINTER OPERATION

printing buildplate;

4. Note: PVP glue is recommended as the glue for printing base plater, which shall be evenly applied

for at least 4 layers. Do not apply PVP glue directly on hot printing buildplate, as the hot printing

buildplate will inactivate PVP glue and weaken its adhesive strength with the base of the printed

piece. Wait until the printing buildplate is cooled to near the room temperature and then apply

glue.

Note: The printing buildplate glass is fragile. Please handle with care in the process of use.

5. Install the printing buildplate. Put the printing buildplate on the hot bed and place the four magnet

blocks on glass into the four corresponding magnet holes on the hot bed. Please note, the glass

should be placed in the way with its notched direction on the inner side of the chamber. After the

placement, gently press the four magnet blocks with hand to confirm that the magnet

blocks be fully seated in magnet holes;

Figure 5. 11 Installation of printing buildplate glass

6. Load material according to the printing task and requirement. Refer to 5.2.1 for detailed steps;

7. Perform the leveling, Z axis calibration and XY axis calibration steps. This step may be skipped if

the leveling and calibration have been completed;

8. The preparation is completed, and the printer is ready to perform printing task formally.

5.4.2 Import the print file into the printer

1. Import the STL model file into the slice software Intamsuite, where the G-code file will be

generated after slicing;

2. The G-code file upon slicing may be placed in two optional positions:

a. U-disk. Copy the file into U-disk and insert the U-disk into the USB port on the right side of

the printer operating panel for reading by the printer;