User's Manual

5 PRINTER OPERATION
49
on screen will be displayed as 100%, indicating the completion of printing. The buildplate and chamber of
the printer may be maintained in certain temperature according to the presetting.
To remove printed piece from the printer:
1. Unlock the door, and open the front door of the chamber. To end the heat maintaining, it just
needs to uncheck the “Maintaining” button, where the front door and cap will be unlocked; to keep
maintaining the temperature, click the door lock button in status bar on screen to unlock the front
door and cap;
2. Click “Axis” interface, and click "Z↓_" button to lower the buildplate to the bottom. At this time, the
buildplate will go down to the bottom of the chamber for taking out the printing buildplate glass
plate;
3. Wear gloves, and take out the buildplate glass plate and printed piece together;
4. Separate the printed piece from the buildplate glass plate carefully with scraper knife. Please note,
the separating shall be operated when the glass plate in hot state is just taken out from the
chamber. This is because the shrinkage of printed piece is far greater than the shrinkage of glass
plate, and the cooled glass plate is vulnerable to damage due to the shrinkage of printed piece.
5. Remove the support material from the printed piece.
5.5 Change Default Settings of the Printer
Figure 5. 17“System” interface
5.5.1 Change the system date and time
The system time of the printer will not be updated automatically according to the time zone of its location,
which requires the manual change by user. Click the “Date / Time” in “System” interface, and change the
date and time in the changing box, and quit the changing box to complete the change.