User's Manual

5 PRINTER OPERATION
50
5.5.2 Enable/disable the function of allowing network remote access
Listen after start: Set to automatically allow the remote access after the system is restarted.
Click the switch on the right side of "Listen after start" in System interface to enbale/disable, where blue
indicates function enabled. Alternatively, manually click the "Listen" button in remote printing service
interface to enbale it manually.
5.5.3 Enable/disable Wifi auto-reconnect
Wifi auto reconnect means the system will automatically connect to the last WiFi network after restart.
Click the switch on the right side of "Wifi auto reconnect" in “System” interface to enbale/disable, where
blue indicates function enabled. Alternatively, click "Connect" button in the WiFi setting interface to
connect manually.
5.5.4 Enable/disable developer mode
Developer mode refers to the mode that the printer opens to developers, which is mainly used for the
debugging of the printer, and is not required in normal printing. Under the developer mode: Enabled
developer mode is available for user to customize the sending G code and enable Logo for fault
diagnosis.
Click the switch on the right side of "Developer mode" in System interface to enbale/disable, where blue
indicates function enabled.
5.5.5 Enable/disable USB printing mode
Usb print enabled refers to the mode under which user can do a printing in direct connection with USB
serial port. When the mode is enabled, the mainboard will disconnect the communication with screen, and
switch to USB serial port equipment communication. It is used for external computer to print by
connecting to the printer via USB serial port. This mode shall be enabled before use, and must be
disabled after use, otherwise the printing in other mode will be impacted.
Click the switch on the right side of "Usb print enabled" in System interface to enbale/disable, where blue
indicates function enabled.
Figure 5. 18 Connection method of USB print mode