User's Manual

6 LEVELING
and Calibration
55
6 Leveling and Calibration
The methods to level and calibrate FUNMATPRO 410 are described in this chapter.
6.1 Manual Leveling and XYZ Calibration
Manual leveling includes the main operations of measuring the 4 points on the buildplate with filler gauge
(in 0.2mm thick), and meanwhile rotating the rotary knobs under the printing buildplate with hand
respectively to keep the same distances from the nozzle cusp of 4 points to the buildplate glass, so as to
make the whole XY motion plane parallel to the buildplate glass. Manual leveling shall only be realized
through the left nozzle.
To realize the dual nozzle printing, it is also required to determine the deviation of right nozzle relatie to
left nozzle on Z direction and XY direction, so the Z calibration and XY calibration are required. To
calibrate the Z deviation, respectively measure the distances between the left/right nozzle cusp and the
buildplate glass with filler gauge, the difference value of which is the Z offset value. To calibrate the XY
offset, the left and right nozzle prints scale on the buildplate glass respectively, on which the X offset value
and Y offset value can be read.
In the “Material” interface, click “M” button to turn to the manual leveling and XYZ calibration interface.
The three steps from left to right are Leveling, Z calibration and XY calibration respectively.
Figure 6. 1 Manual leveling and XYZ calibration steps
Use may selectively perform any one or several steps, but the three steps from left to right must be
performed in order. The step(s) not required may be skipped by clicking the "Skip" button under such
step(s).
After different operations, the following table will guide user to selectively perform the step(s) among
three.