User's Manual

6 LEVELING

and Calibration

Figure 6. 7 Press the quick snap joint and pull out the feeding pipe

3. In the “System” interface, click the "Set" on the right side of the “L-Clamper”display box. At this

time, the nozzle is switched to left nozzle again, and the clamping value is refreshed to 0.

Figure 6. 8 Material calibration interface

4. Insert the clamping value calibration bar between the drive gear and the driven gear along the

channel of filament. Pull the calibration bar up and down and meanwhile click the "←" button on

screen until you feel the calibration bar just touches the gears on both sides. At this time, the drive

gear just reach its suitable position. Click the "Set" button on screen to load the calibration value

of clamp force.