Installation Guide

18
STEP 9: ALL ROOF PANELS
Components Needed
 13” wide “W” roof panel (J)
 #10 x 3/8” sheet metal screw
 Preformed flashing (N)
 Sealant tube & gun
Tools Recommended
FIRST: Slide new roof panel back into hanging
channel and firmly into foam rubber gasket.
Seal panel ends to foam rubber gasket. Align
new roof panel on 12” mark before securing
with #10 x 3/8” sheet metal screw in panel
“valley” at front fascia.
SECOND: Continue installing each 13” wide
“W” roof panel securely and seal generously
at seams.
Repeat with remaining roof panels until 50%
across roof panels are installed.
Secure Post bottom brackets in next step then
complete remaining roof panels.
THIRD: Install preformed flashing into grove
on hanging rail. Position over first and second
panels. Bend tabs down so they fit snug on
surface of roof panel.
Screw flashing to peaks of roof panels using
#10 x 3/8” sheet metal screws. Seal the top of
screw heads.
NOTE: Each panel must align on 12” mark from early steps before securing and moving to
next panel installation. Overall patio cover width may require to secure and seal roof panels
at varying steps due to access.