Installation Guide

Need help with installation? www.homedepot.com/services/pergola-installation/
SKIP THIS STEP FOR WIDTH BELOW 16 ft
Components List
 Front fascia rails (D)
 Front fascia splice (E)*
 Tek screws
 Sealant tub & gun
Tools Required
STEP 1: Locate & pull splice to mark splice
insert piece with a center mark at 13” from
each end with carpenter pencil.
STEP 2: Slide end of first front fascia piece
aligning STEP 1 center mark even between
two rails.
STEP 3: Connect 2
nd
piece into other end of
splice insert piece end to match STEP 1
center mark from other side. Secure with
white Tek screws from bottom exterior.
STEP 4: Secure splice using 3/8” socket drive
and twelve ¼” x 3/4” Tek screws at 1”, 11”,
13”, and 23” from ends of splice. Caulk all
connections and ends generously.
This step only applies to patio covers with a total front width that is greater
than 16 feet wide due to shipping limitations. Installer needs to splice two
front fascia pieces together by inserting a “front fascia splice” insert.