Owner's Manual

12
Front & Rear Panels—Continued
m FM ANTENNA
This jack is for connecting an FM antenna.
AM ANTENNA
These push terminals are for connecting an AM
antenna.
n IR IN/OUT
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
AV controller while you’re in Zone 2, or control it
when it’s out of sight, for example, installed in a
cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals through to other components.
o 12V TRIGGER OUT (A/B/C)
These outputs can be connected to the 12-volt trig-
ger inputs on other components.
p AC INLET
The supplied power cord is connected here. The
other end of the power cord should be connected to
a suitable wall outlet.
q GND screw
This screw is for connecting a turntable’s ground
wire.
r PHONO IN
These analog audio inputs are for connecting a turn-
table.
s CD IN
These analog audio inputs are for connecting a CD
player’s analog audio output.
t TV/TAPE IN/OUT
These analog audio inputs and outputs are for con-
necting a TV or recorder with an analog audio input
and output (cassette, Mini Disc, etc.).
u GAME IN
Here you can connect a game console, etc. Input
jacks include S-Video, composite video, and analog
audio.
v CBL/SAT IN
Here you can connect a cable/satellite receiver, set-
top box, etc. Input jacks include S-Video, composite
video, and analog audio.
w VCR/DVR IN/OUT
Here you can connect a VCR or DVR (digital video
recorder). Input and output jacks include S-Video,
composite video, and analog audio.
x DVD/BD IN
Here you can connect a DVD/BD player. Input
jacks include S-Video, composite video, and analog
audio. You can connect a DVD/BD player’s 2-chan-
nel analog audio output.
y PRE OUT: FRONT L/R, CENTER, SURR L/R,
and SURR BACK L/R
These multichannel analog audio outputs can be
connected to the analog audio input on a multichan-
nel power amplifier.
z PRE OUT: SUBWOOFER
This analog audio output can be connected to a
powered subwoofer. You can connect the powered
subwoofer with two PREOUT: SUBWOOFER
jacks respectively. The same signal is output from
each jack.
A PRE OUT: ZONE 2 L/R
These analog audio outputs can be connected to the
line inputs on amplifiers in Zone 2.
See pages 17 to 38 for connection information.