Owner's Manual

127
Zone 2—Continued
Notes:
• Only analog input sources are output by the ZONE 2
PRE OUT. Digital input sources are not output. If no
sound is heard when an input source is selected, check
if it’s connected to an analog input.
• You cannot select different AM or FM radio stations
for your main room and Zone 2. The same AM/FM
radio station will be heard in each room. For example,
if you have an FM station for the main room, that sta-
tion will also be used in Zone 2.
• When the input selector of Zone 2 is selected, power
consumption on standby mode slightly increases.
• While Zone 2 is on, u functions will not work.
Adjusting the Volume for Zone 2
Muting Zones
Note:
Zones can also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zones
Note:
The Zone 2 volume, tone, and balance function cannot
be set when the “Zone2 Out” setting is set to “Fixed”
(page 125).
Remote
controller
On the remote controller, press
the [Zone2] button, and then use
the VOL [q]/[w] button.
AV controller
On the AV controller, press the
Zone 2 Level Down and Up [w]/[q]
buttons.
Remote
controller
On the remote controller, press
the [Zone2] button, and then
press the [Muting] button.
To unmute a zone, on the remote
controller, press the [Zone2]
button, and then press the
[Muting] button again.
1
AV controller
On the AV controller, press the
[Zone 2] button.
2
Press the AV controller’s [Tone]
button repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use the Down and Up [–]/[+]
buttons to adjust the bass, treble
or balance.
• You can boost or cut the bass or tre-
ble from –10 dB to +10 dB in 2 dB
steps.
• You can adjust the balance from 0 in
the center to +10 dB to the right or
+10 dB to the left in 2 dB steps.