Owner's Manual

44
First Time Setup—Continued
Notes:
• See page 25 for charts showing how the “Monitor
Out” and “Resolution” settings affect the video signal
flow through the AV controller.
• This procedure can also be performed on the AV
controller by using its [Setup] button, arrow buttons,
and [Enter] button.
Notes:
• If not connected to the same output
you have selected in the“Monitor
Out” setting, the “Monitor Out”
setting will be automatically
switched to “Analog” (see page 26).
• When you select other than
“Analog”, the onscreen setup menus
are output by only the HDMI
outputs. If you’re not using the
HDMI output and select settings
by mistake and the menus
disappear, use the [Video] and
Arrow buttons so that “Monitor
Out: Analog” appears on the
display.
• For Deep Color output, if the
“Monitor Out” setting is set to “Both
(Main)” or “Both (Sub)”, the number
of bit may be limited due to the
capability of your TV connected to a
priority output.
5
Use the Up and Down [q]/[w] but-
tons to select “Resolution”, and
use the Left and Right [e]/[r]
buttons to select:
Through:
Select this to pass video through the
AV controller at the same resolution
and with no conversion.
Auto :
Select this to have the AV controller
automatically convert video at reso-
lutions not supported by your TV.
480p:
Select this for 480p output and
video conversion as necessary.
720p:
Select this for 720p output and
video conversion as necessary.
1080i:
Select this for 1080i output and
video conversion as necessary.
1080p :
Select this for 1080p output and
video conversion as necessary.
Source:
Output will be according to the res-
olution level which was set in the
“Picture Adjust” setting (see
page 101).
*
*
Tips:
• The “Resolution” setting can also be
set using the [Video] button on the
remote controller.
• The “Resolution” setting is set
respectively of main, sub, and
analog.
Notes:
• Settings marked with an asterisk ( )
are not available when the “Monitor
Out” setting is set to “Analog”.
• If the “Monitor Out” setting is set to
“Both”, this setting is fixed at
“Auto”.
6
Press the [Setup] button.
The setup menu closes.
*