Owner's Manual

First Time Setup—Continued

For FM/AM tuning to work properly, you must specify

the FM/AM frequency step used in your area. Note that

when this setting is changed, all radio presets are

deleted.

Note:

This procedure can also be performed on the AV control-

ler by using its [Setup] button, arrow buttons, and [Enter]

button.

FM/AM Frequency Step Setup

Press the [Receiver] button, fol-

lowed by the [Setup] button.

The main menu appears onscreen.

If the main menu doesn’t appear, make

sure the appropriate external input is

selected on your TV.

Use the Up and Down [q]/[w] but-

tons to select “7. Hardware

Setup”, and then press [Enter].

The “Hardware Setup” menu appears.

Use the Up and Down [q]/[w] but-

tons to select “3. Tuner”, and

then press [Enter].

The “Tuner” menu appears.

Use the Left and Right [e]/[r]

buttons to select:

200kHz/10kHz:

Select if 200 kHz/10 kHz steps are

used in your area.

50kHz/9kHz:

Select if 50 kHz/9 kHz steps are

used in your area.

7. Hardware Setup

1. Remote ID

2. Multi Zone

3. Tuner

4. HDMI

5. Network

6. Firmware Update

7–3. Tuner

FM/AM Frequency Step

SAT Radio Mode

200kHz/10kHz

None

Press the [Setup] button.

The setup menu closes.