Owner's Manual

50
First Time Setup—Continued
Notes:
• If the video source contains information that restricts
output at high-resolutions, 720p or 1080i content will
not be converted.
• See page 30 for charts showing how the “Monitor
Out” and “Resolution” settings affect the video signal
flow through the AV controller.
• This procedure can also be performed on the AV con-
troller by using its [Setup] button, arrow buttons, and
[Enter] button.
HDMI Input Setup
If you connect a video component to an HDMI IN, you
must assign that input to an input selector. For example,
if you connect your DVD player to HDMI IN 1, you
must assign HDMI IN 1 to the DVD input selector.
By default, none of the HDMI inputs are assigned.
If you’ve connected your TV to the AV controller with
an HDMI cable, you can set the AV controller so that
composite video, S-Video, and component video sources
are upconverted
*
and output by the HDMI outputs. You
can set this for each input selector by selecting the “- - -”
option.
5
Use the Up and Down [q]/[w] but-
tons to select “Resolution”, and
use the Left and Right [e]/[r]
buttons to select:
Through:
Select this to pass video through the
AV controller at the same resolution
and with no conversion.
Auto:
Select this to have the AV controller
automatically convert video at reso-
lutions not supported by your TV.
(Not available when the “Monitor
Out” setting is set to “Analog”.)
480p:
Select this for 480p output and
video conversion as necessary.
720p:
Select this for 720p output and
video conversion as necessary.
1080i:
Select this for 1080i output and
video conversion as necessary.
1080p:
Select this for 1080p output and
video conversion as necessary. (Not
available when the “Monitor Out”
setting is set to “Analog”.)
Source:
Output will be according to the res-
olution level which was set with
Resolution inside Source:
4-4. Picture Adjust. (Setting for
each Source becomes possible.)
6
Use the Up and Down [q]/[w] but-
tons to select “Component
Out2”, and use the Left and Right
[e]/[r] buttons to select:
Monitor:
Select this if you’ve connected the
COMPONENT VIDEO MONI-
TOR OUT 2/ZONE 2 OUT to a TV
or other component in your main
room.
Zone 2:
Select this if you’ve connected the
COMPONENT VIDEO MONI-
TOR OUT 2/ZONE 2 OUT to a TV
in Zone 2.
When Monitor is selected, the COM-
PONENT VIDEO MONITOR OUT
2/ZONE 2 OUT outputs the same video
as the COMPONENT VIDEO MON-
ITOR OUT 1.
7
Press the [Setup] button.
Setup closes.
Enter
Enter
Enter
Enter
S
e
t
u
p
Video Input Setup
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “1. Input/Output
Assign”, and then press [Enter].
The “Input/Output Assign” menu
appears.
IN
OUT
Composite video, S-Video,
component video
Composite video, S-Video,
component video
HDMI
HDMI
Receiver
S
e
t
u
p
Enter
Enter
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input