Owner's Manual

60
First Time Setup—Continued
3
Press [Enter].
The automatic speaker setup starts.
Test tones are played through each
speaker as Audyssey MultEQ
®
XT
Automatic Speaker Setup runs. This
process takes a few minutes. Please
refrain from talking during
measurements and do not stand
between speakers and the microphone.
4
The speaker detect results
appear.
“Yes” means that the speaker was
detected. “No” means that no speaker
was detected.
If you agree with the results, use
the Up and Down [q]/[w] buttons
to select “Next”, and then press
[Enter].
The options are:
Next: Proceed to the next step.
Retry: Return to step 2 and try again.
Cancel: Cancel the automatic speaker
setup.
Enter
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
2
Enter
Enter
Auto Speaker Setup
Speaker Detect Result
Next
Retry
Cancel
ENTER
ENTER
MOVE
:Yes :No
5
The following screen appears.
Place the setup microphone at
the next position (see page 58),
and then press [Enter].
Audyssey MultEQ
®
XT performs more
measurements. This takes a few minutes.
6
When prompted, place the setup
microphone at the next position,
and repeat step 5.
7
After the 3rd or 7th measure-
ment, the following screen
appears.
Use the Up and Down [q]/[w] but-
tons to select an option, and then
press [Enter].
Next:
Select “Next” to begin measuring
the next measurement position.
After the 8th measurement has been
taken, the procedure automatically
proceeds to step 8.
Finish(Calculate):
Select this if you don’t want to
measure any more listening posi-
tions and are ready to calculate the
results, then go to step 8.
Auto Speaker Setup
Please place microphone at next position at ear height.
Next
ENTER
ENTER
2
Enter
Auto Speaker Setup
Do not unplug Setup Mic.
Please keep quiet.
Now measuring. . .
2
Enter
Enter
Auto Speaker Setup
Select [Next] to measure the next position, or select
[Finish] to calculate the Audyssey MultEQ room EQ
solution.
Next
Finish(Calculate )
ENTER
ENTER
MOVE