Owner's Manual

14
Controls & Connectors—Continued
A VIDEO OUTPUT
This RCA connector can be used to connect a TV or
projectors with composite video inputs.
B IR IN/OUT (24)
The IR IN connector can be used to connect a com-
mercially available IR receiver, which can be used
to pickup signals from the remote controller when
the DPS-5.9 is located in another room, installed in
a rack, or is out of range of the remote controller.
The IR OUT connector can be used to connect a
commercially available IR emitter, which can be
used to pass remote controller signals received by
the IR IN along to other AV components.
C RS 232
This port is for servicing.
D REMOTE CONTROL
These (Remote Interactive) connectors can be
connected to the connectors on your other Inte-
gra/Onkyo AV components for interactive control.
Connecting an cable only does not make the
system operational. You must also connect the audio
cables as well.
If you’re using RIHD, do not connect anything to
these connectors.
E ANALOG AUDIO OUTPUT
These RCA connectors can be connected to the ana-
log audio inputs on a hi-fi amp or AV receiver.
F OPTICAL AUDIO OUTPUT
This optical digital audio output can be connected
to an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
G COAXIAL AUDIO OUTPUT
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS) with supplied coaxial digital cable.
H HDMI OUT
This HDMI jack outputs digital video and audio and
can be connected to an HDMI input on a compatible
TV or other component.
I S VIDEO OUTPUT
This connector can be used to connect TV or projec-
tor with S-Video input.
J COMPONENT 1 VIDEO OUTPUT
These RCA connectors can be used to connect a TV
or projector with RCA component video inputs.
The DPS-5.9 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
K COMPONENT 2 VIDEO OUTPUT
These BNC connectors can be used to connect a TV
or projector with BNC component video inputs.
The DPS-5.9 has two component video outputs, the
COMPONENT 1 and COMPONENT 2, however,
they output the same video signal.
L AC INLET
The supplied power cord connects to this polarized
inlet. The other end of the power cord should be
connected to a suitable wall outlet. On the Austra-
lian model, the power cord is not polarized.
Rear Panel
A
FGHI JK L
BC DE
See page 18–24 for connection information.