Owner's Manual

50
Configuring the DPS-5.9—Continued
HDMI Control
With this setting, you can turn RIHD control over HDMI
on or off.
On (default): RIHD control on.
Off: RIHD control off.
Notes:
• RIHD (Remote Interactive over HDMI) is Onkyo’s
implementation of CEC (Consumer Electronics Con-
trol), which allows integrated system control over
HDMI and is part of the HDMI standard. In addition
to Integra/Onkyo AV components, it allows interoper-
ability with CEC-compatible AV components and TVs
made by other manufacturers. However, operation
with components other than RIHD-compatible com-
ponents or recommended components cannot be guar-
anteed.
• Select Off if a connected component is incompatible
or you’re not sure about its compatibility.
• If operation is unreliable when set to On, select Off
instead.
Power Control
With this setting, you can turn RIHD power control over
HDMI on or off.
On (default): RIHD power control on.
Off: RIHD power control off.
Notes:
• The Power Control setting can be set only when the
HDMI Control setting is set to On.
• When set to On, the DPS-5.9 can be turned on or off
automatically along with the other RIHD-compatible
components in the system.
• HDMI power control only works with RIHD-compat-
ible components that support it and may not work
properly with some components due to their settings
or compatibility.
• When set to On, the DPS-5.9 consumes more power.
Direct Change
With this setting, you can turn RIHD direct change over
HDMI on or off.
On (default): RIHD direct change on.
Off: RIHD direct change off.
Notes:
• The Direct Change setting can be set only when the
HDMI Control setting is set to On.
• When set to On, when playback is started on the
DPS-5.9, it will automatically be selected as the input
source on an RIHD-compatible TV or AV receiver.
• HDMI direct change only works with RIHD-compat-
ible components that support it and may not work
properly with some components due to their settings
or compatibility.
Auto Power Off
The Auto power off function automatically turns off the
DPS-5.9 after 20 minutes of inactivity.
This menu appears automatically the very first time you
turn on the DPS-5.9. See “First Time Setup” on page 26
for more information.
TV Shape—see page 45
HDMI Output Setting—see page 46
On-Screen Language—see page 48
This section explains how to select other languages for
disc menus, audio, and subtitles.
Initial Setup Menu
Selecting Other Languages
1
Select “Others” from the Disc
Menu Language, Audio Lan-
guage, or Subtitle menu, and
then press [Enter].
The language code boxes appear.
2
Use the remote controller’s Left/
Right [ ]/[ ] buttons to select the
code boxes.
Use the Up/Down [ ]/[ ] buttons
to enter a language code.
See adjacent table for language codes.
3
When you’ve finished, press the
[Enter] button.
Remote controller
Remote controller
Remote controller