Owner's Manual

55
Troubleshooting—Continued
If you’re using an HDMI connection and there’s no picture or sound, you can check the status of the HDMI connection
by pressing and holding down the DPS-5.9’s [Display] button for 10 seconds until a message ID appears on the display.
Look up the message ID in the following tables and check the HDMI connections and settings on both the DPS-5.9 and
the connected component.
HDMI connection and HDMI-related settings status
No picture from the HDMI connection
No sound from the HDMI connection
■ Abnormal Behavior
The DPS-5.9 contains a microcomputer for signal processing and control functions. In very rare situations, severe
interference, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this
should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again.
Alternatively, press and hold the Stop [ ] button until “RESET” appears on the display (about 10 seconds).
■ Restoring the Default Settings
To reset the DPS-5.9 to its factory defaults, turn it on, and when “INTEGRA DVD” has disappeared from the display,
while holding down the Stop [ ] button, press the [On/Standby] button. “INITIALIZE” appears on the display. When
the reset is complete, “COMPLETE” is displayed, and the DPS-5.9 enters Standby mode.
■ HDMI Status Mode
Displayed ID Message
MSG ID 001
MSG ID 005
MSG ID 015
Turn the DPS-5.9 and the connected component off, then turn them on again. Make sure that the
connected component is working properly and that the DPS-5.9’s HDMI settings are configured
suitably for that component.
Displayed ID Message
MSG ID 002 The HDMI Output Setting is set to Off. Change it to On (page 27).
MSG ID 003
MSG ID 004
The HDMI cable may not be connected properly. Check the connection. Also, make sure the HDMI
input on the TV or AV receiver is correctly configured to received HDMI.
MSG ID 005
MSG ID 006
MSG ID 007
Make sure the HDMI input on the TV or AV receiver is correctly configured to received HDMI.
The connected component may not support HDCP. Make sure the connected component supports
HDCP.
Turn the DPS-5.9 and the connected component off, then turn them on again.
The DPS-5.9 may be connected to the other component’s DVI jack. Some TVs may not properly
receive the video output by the DPS-5.9. Also, with a DVI connection, there will be no sound.
MSG ID 008
The DPS-5.9’s HD Resolution setting is set to 480i or 720p or 1080i or 1080p. If your TV doesn’t
support these resolutions, select another resolution (page 27).
MSG ID 009
The connected component may not be receiving the HDMI signal properly.
Tr y selecting another resolution on the DPS-5.9 (page 27).
Displayed ID Message
MSG ID 010
The DPS-5.9’s Digital/HDMI Audio Out setting is set to Off. Change the setting to All or PCM
(page 47).
MSG ID 011
MSG ID 014
The connected component may not support 96 kHz PCM. Set the DPS-5.9’s Linear PCM Out set-
ting to Down Sample On (page 47).
MSG ID 012
MSG ID 013
The connected component may not support Dolby Digital. Set the DPS-5.9’s Digital/HDMI Audio
Out setting to PCM (page 47).
MSG ID 016
MSG ID 017
The connected component may not support DTS.
The DPS-5.9 cannot play the DTS format audio or soundtrack. On your DVD-Video disc’s audio
setup menu, select an audio format other than DTS.