User Manual

16
Connections with Bi-Amping speakers (Page 12)
The illustration at left shows an example of connection
using the PRE OUT (RCA) jacks. Refer to the illustration at
left also when connecting using the PRE OUT (XLR) jacks.
Both connections use the FRONT jacks and HEIGHT 1
jacks. Connect each of the PRE OUT jacks to the input
jacks on the power amplifier. Make sure you remove the
jumper bar fitted between the woofer jacks and tweeter
jacks of the front speakers. In case of Bi-Amping
connection, refer to the instruction manual of your
speakers.
> Before Start > Part Names >Install > Initial Setup > Playback > Advanced Manual
Troubleshooting | Supplementary Information, etc.
＋−＋− ＋− ＋−
LRLR
FRONT
CENTER
12
BACK HEIGHT
SUR
-
ROUND
1
2
L
R
SUBWOOFER
PRE OUT
L
R
a
For high-
frequency
For low-
frequency
Power amplifier
a Analog Audio Cable
Setup
0 Settings for the speaker configuration you have
connected need to be made in "1. AccuEQ Room
Calibration" in Initial Setup (P26).