User Manual

14
> Specifications > Advanced Setup > Listening Modes
> Network Functions > Basic Manual
|Troubleshooting Supplementary Information, etc.
Setting Item Default Value Setting Details
Double Bass On This can be selected only when "Configuration" -
"Subwoofer" is set to other than "No" and "Front" is
set to "Full Band".
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted
"Off": Bass output will not be boosted
•
The setting will not automatically be configured
even if you performed AccuEQ Room
Calibration.
■ 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 12' 0" / 3.60 m Specify the distance between each speaker and
the listening position.
Center 12' 0" / 3.60 m Specify the distance between each speaker and
the listening position.
Front Right 12' 0" / 3.60 m Specify the distance between each speaker and
the listening position.
Height 1 Left 9' 0" / 2.70 m Specify the distance between each speaker and
the listening position.
Height 1 Right 9' 0" / 2.70 m Specify the distance between each speaker and
the listening position.
Height 2 Left 9' 0" / 2.70 m Specify the distance between each speaker and
the listening position.
Height 2 Right 9' 0" / 2.70 m Specify the distance between each speaker and
the listening position.
Surround Right 7' 0" / 2.10 m Specify the distance between each speaker and
the listening position.
Surr Back Right 7' 0" / 2.10 m Specify the distance between each speaker and
the listening position.
Setting Item Default Value Setting Details
Surr Back Left 7' 0" / 2.10 m Specify the distance between each speaker and
the listening position.
Surround Left 7' 0" / 2.10 m Specify the distance between each speaker and
the listening position.
Subwoofer 1 12' 0" / 3.60 m Specify the distance between each speaker and
the listening position.
Subwoofer 2 12' 0" / 3.60 m Specify the distance between each speaker and
the listening position.
•
Default values vary depending on the regions.
•
Distance units can be switched by pressing Mode on the remote controller. When the unit is set as
feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit is set as meters,
you can set between 0.01 m and 9.00 m in increments of 0.01 m.