Owner's Manual

102
Playback
Connecting a transmitter for playback
When you connect wireless headphones or a wireless speaker transmitter to the ZONE B LINE OUT jacks of this unit, you can play back the same source through the
wireless headphones or wireless speakers as in the main room.
Connections
1. Use an analog audio cable to connect the ZONE B LINE OUT jacks on this
unit to the input terminal on the transmitter.
a
Transmitter
Setting Up
1. Press on the remote controller, and set "2. Speaker" - "Conguration" -
"Zone 2 Preout" to "Zone B". ( →p113)
Playing Back
1. Press the Q button on the remote controller and select "Audio" - "Zone B".
• In the following cases, "Zone B" cannot be selected.
– When ZONE 2 is On
– When "2. Speaker" - "Conguration" - "Zone 2 Preout" on the Setup
menu is set to "Zone 2". ( →p113)
2. Select the audio output destination.
Off: Outputs audio only from ZONE A. "A" on the display of the main unit lights up.
On (A+B): Outputs audio from both ZONE A and ZONE B. "A" and "B" on the
display of the main unit light up.
On (B): Outputs audio only from ZONE B. "B" on the display of the main unit
lights up.
3. Start play on the AV component.
4. Adjust the volume on the transmitter, etc., in ZONE B.
• When "Zone 2 Preout" is set to "Zone B", and "Audio" - "Zone B" on the Quick
Menu is set to "On (A+B)", the ZONE A output is set as below.
– For ZONE A, sound quality adjustment with the Tone button is possible
only for the Front speakers.
– There will be no effect for the surround back speakers from "2.Speaker" -
"Distance" ( →p115) in the Setup menu.
• If "On (A+B)" is selected as an audio output destination, you can select only
the "Stereo" listening mode for ZONE A when using the 2.1 ch speaker layout.
When using a speaker layout of 3.1 ch or more, you can select only the "AllCh
Stereo" listening mode.
a Analog audio cable