Owner's Manual

113
SetupSetup
2. Speaker
 Height 2 Speaker (Default Value: Rear High)
Set the speaker type if height speakers are connected to the HEIGHT 2
terminals. Select "Front High", "Top Front", "Top Middle", "Top Rear", "Rear
High", "Dolby Speaker (Front)" or "Dolby Speaker (Surr)" according to the type
and layout of the connected speakers. However, the options selectable for the
"Height 1 Speaker" are as follows.
If "Height 1 Speaker" is set to "Front High": Select from "Top Middle", "Top
Rear", "Rear High" or "Dolby Speaker (Surr)".
If "Height 1 Speaker" is set to "Top Front" or "Dolby Speaker (Front)": Select
from "Top Rear", "Rear High" or "Dolby Speaker (Surr)".
If "Height 1 Speaker" is set to "Top Middle": Fixed to "Rear High".
• "Dolby Speaker (Surr)" can only be selected when surround speakers
are being used. You can check speakers that you are using on the gure
displayed in "Speaker Channels".
• If an item cannot be selected even though connection is correct, check
that the settings in "Speaker Channels" matches the number of connected
channels.
 Zone Speaker (Default Value: No)
Set whether ZONE 2 speakers and ZONE 3 speakers are being used.
• This setting cannot be selected when "Zone 2 Preout" is set to "Zone B".
Zone 2 When ZONE 2 speakers are used
Zone 2/Zone 3 When both ZONE 2 speakers and ZONE 3 speakers are used.
• This setting cannot be selected under any of following
conditions.
– When the surround back speakers are used
– When height speakers are being used
No When neither ZONE 2 speakers nor ZONE 3 speakers are
used
 Zone 2 Preout (Default Value: Zone 2)
Set an output destination of the audio output from ZONE 2 PRE/LINE OUT/
ZONE B LINE OUT jack.
• This setting is xed to "Zone 2" when "Zone Speaker" is set to "Zone 2" or
"Zone 2/Zone 3".
Zone 2 When connecting an integrated amplier in a separate room
(Zone 2)
Zone B When connecting an integrated amplier, transmitter of
wireless headphones, etc. to ZONE B
 Bi-Amp (Default Value: No)
Set whether the front speakers are bi-amp connected.
No When front speakers are not bi-amp connected
Yes When front speakers are bi-amp connected
• This setting will be set to "No" in either of following cases.
– When 2 sets of height speakers are used
– When surround back speakers and height speakers are
being used at the same time.
– When "Zone Speaker" is set to "Zone 2" or "Zone 2/Zone
3"
 Speaker Impedance (Default Value: 6 ohms or above)
Set the impedance (Ω) of the connected speakers.
• For impedance, check the indications on the back of the speakers or their
instruction manual.
4ohms When any of the connected speakers have 4 Ω or more to less
than 6 Ω impedance
6 ohms or above When all the connected speakers have an impedance of 6 Ω
or more