Owner's Manual
Table Of Contents
- What’s in the box
- Connections
- Playback
- AV Component Playback
- BLUETOOTH® Playback
- Internet Radio
- Spotify
- AirPlay®
- DTS Play-Fi®
- FlareConnectTM
- USB Storage Device
- Playing back files on a PC and NAS (Music Server)
- Play Queue
- Amazon Music
- Connecting the Sonos System for Playback
- Listening To the AM/FM Radio
- Multi-zone
- ZONE B Playback
- Convenience functions
- Listening Mode
- Inputting Characters
- Setup
- Troubleshooting
- Appendix
118
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Playing Back (ZONE 3)
In remote controller operation, while pressing and holding the Zone 3 button,
press other buttons for operation.
1. While pressing and holding the Zone 3 button on the remote controller, point
the remote controller at this unit and press .
• "Z3" on the display of the main unit lights up.
2. While pressing and holding the Zone 3 button on the remote controller, press
the input selector of the input source you want to play in the separate room. To
control on the main unit, press the Zone 3 button, and then within 8 seconds,
press the input selector button of the input to be played in the separate room.
To play the same source in the main room and separate room, press the Zone
3 button of the main unit twice.
3. If the unit is connected to the pre-main amplier in the separate room, adjust
the volume on the pre-main amplier. If the unit is connected to the power
amplier or ZONE speaker in the separate room, adjust the volume with the
volume button while pressing and holding the Zone 3 button on the remote
controller. To do this on the main unit, press the Zone 3 button, and then within
8 seconds, adjust the volume using the Master Volume dial.
• When connecting the power amplier, set "7. Multi Zone" - "Zone 3" -
"Output Level" (
p182) to "Variable" on the Setup menu. If it is not set,
a large volume is output and the power amplier, speakers, etc. may be
damaged.
• If you turn the unit to standby during multi-zone playback, the Z3 indicator is
dimmed, and the playback mode is switched to playback in a separate room
only. Setting ZONE 3 to on while the unit is in standby also switches the
playback mode to playback in the separate room only.
• For ZONE 3 output, audio from externally connected AV components can be
output only when it is an analog audio signal.
• DSD audio signals cannot be output to ZONE 3 with the "NET" input selector.
• If ZONE 3 is on, power consumption during standby will increase.
To disable the function: While pressing and holding the Zone 3 button on the