Owner's Manual

14
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Front Panel≫ Rear Panel≫ Remote≫
1. COMPONENT VIDEO IN jacks: Input AV component video signals with a
component video cable. (Compatible only with 480i or 576i resolution.)
2. Wireless antenna: Used for Wi-Fi connection or when using a BLUETOOTH-
enabled device. Adjust the angles according to the connection status.
3. VIDEO IN jacks: Input AV component video signals with an analog video cable.
4. AUDIO IN jacks: Input AV component audio signal with an analog audio cable.
5. HDMI IN jacks: Transmit video signals and audio signals with an HDMI cable
connected to an AV component.
6. GND terminal: Connect the ground wire of the turntable.
7. HDMI OUT jacks: Transmit video signals and audio signals with an HDMI
cable connected to a monitor such as a TV or projector.
8. USB port: Connect a USB storage device to play music les. ( p96)
You can also supply power (5 V/1 A) to USB devices with a USB cable.
9. ETHERNET port: Connect to the network with a Ethernet cable.
10. DIGITAL IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
11. AC INLET: The supplied power cord is connected.
12. RS232 port: Connect a home control system equipped with an RS232 port.
For adopting a home control system, contact the specialized stores.
13. TUNER AM/FM terminal: Connect the supplied antennas.
14. IR IN 1/2, IR OUT port: Connect a remote control receiver unit. ( p83)
15. ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplier or a power amplier in a separate
room (ZONE 2).
ZONE B LINE OUT jacks: Connect to a pre-main amplier with an analog
audio cable, and simultaneously output audio of the same source as that of
the speakers (ZONE A) connected to this unit.
16. 12V TRIGGER OUT A/B jacks: Connect a device equipped with a 12V trigger
input jack to enable power link operation between the device and this unit.
( p84)
17. ZONE 3 PRE/LINE OUT jacks: Output audio signals with an analog audio
cable connected to a pre-main amplier or a power amplier in a separate
room (ZONE 3).
18. SPEAKERS terminals: Connect speakers with speaker cables. (North
American models support banana plugs. Use a plug 4 mm in diameter. Y plug
connection is not supported.)
19. SUBWOOFER PRE OUT jack: Connect a powered subwoofer with a
subwoofer cable. Up to two powered subwoofers can be connected. You can
set the volume levels of the 2 powered subwoofers to different levels.
( p162)
20. PRE OUT jacks: Connect to a power amplier. ( p67)
21. RS232 port: Used for connection with the HDBaseT Receiver. Refer to the
Instruction Manual included with the HDBaseT Receiver for usage instructions.
22. IR IN/OUT jacks: Used for connection with the HDBaseT Receiver. Refer
to the Instruction Manual included with the HDBaseT Receiver for usage
instructions.
23. 12V 1A INPUT jack / ON/OFF switch: Used for connection with the HDBaseT
Receiver. Refer to the Instruction Manual included with the HDBaseT Receiver
for usage instructions.
24. HDBaseT™ IN/OUT jack: The input signals are output via the Ethernet cable.
As they are covered with a seal when shipped, remove it when you use the
ports. Do not use the ports to connect the ETHERNET port of network device.