Owner's Manual
Table Of Contents
- What’s in the box
- Connections
- Playback
- AV Component Playback
- BLUETOOTH® Playback
- Internet Radio
- Spotify
- AirPlay®
- DTS Play-Fi®
- FlareConnectTM
- USB Storage Device
- Playing back files on a PC and NAS (Music Server)
- Play Queue
- Amazon Music
- Connecting the Sonos System for Playback
- Listening To the AM/FM Radio
- Multi-zone
- ZONE B Playback
- Convenience functions
- Listening Mode
- Inputting Characters
- Setup
- Troubleshooting
- Appendix
160
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Height 2 80 Hz (THX) Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
Surround 80 Hz (THX) Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when "Front" is
set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
Surround Back 80 Hz (THX) Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
• "Full Band" can be selected only when
"Surround" is set to "Full Band".
• If the item cannot be selected even though
connection is correct, check if the setting in
"Conguration" - "Speaker Channels" matches
the number of connected channels.
LPF of LFE 120 Hz Set the low-pass lter for LFE (low-frequency
effect) signals in order to pass only the lower
frequency signals than the set value, and thus
cancel unwanted noises. The low-pass lter is
effective only on sources with LFE channel.
The value from "80 Hz" to "120 Hz" can be set.
"Off": When this function is not used
Setting Item Default Value Setting Details
Double Bass On This can be selected only when "Conguration" -
"Subwoofer" is set to "1ch" or "2ch" and "Front" is
set to "Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"Off": Bass output is not boosted.
• This function is not automatically set even if
AccuEQ Room Calibration is performed.
• This setting is disabled when the IMAX sound mode has been applied. However, when
the "IMAX User Setting" (
p166) is "Manual" (default value is Auto), it is enabled.