Owner's Manual

166
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
 2. Dolby
Change the setting of when Dolby signals are input.
Setting Item Default Value Setting Details
Loudness
Management
On When playing Dolby TrueHD, enable the dialog
normalization function which keeps the volume of
dialog at a certain level. Note that when this setting
is Off, the Late Night function that allows you to
enjoy surround at low volumes is xed to off when
playing Dolby Digital Plus/Dolby TrueHD.
"On": When this function is used
"Off": When this function is not used
 3. DTS/IMAX
Change the setting of when DTS signals are input.
Setting Item Default Value Setting Details
DTS Auto
Surround
On When inputting DTS signals that include extended
channel information, the optimum listening mode is
automatically selected according to the extended
information contained in the input signal and the
speaker conguration of this unit when playing in
the straight decoding listening mode.
"On": When this function is used
"Off": Audio is played using the same number
of channels in the input signal according to the
speaker conguration of this unit.
• If this function is set to "Off", the ES Matrix and
ES Discrete listening modes cannot be selected.
Dialog Control 0 dB You can increase the volume of dialog portion of
the audio up to 6 dB by 1 dB step so that you can
hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not
be selected.
Setting Item Default Value Setting Details
IMAX Mode Auto Set the IMAX sound mode.
"Auto": IMAX sound mode is automatically applied
when IMAX content is detected.
"On": In cases when this unit is unable to recognize
IMAX content, you can apply the IMAX sound
mode by turning this setting "On".
"Off": The setting is disabled.
IMAX User
Setting
Auto When playing IMAX content with the IMAX sound
mode, select whether to automatically apply the
speaker setting recommended by IMAX or to set it
manually.
"Auto": To use the speaker setup recommended by
IMAX.
"Manual": To manually set "IMAX Bass Feeding"
and "IMAX LFE Level".
• This cannot be selected when the IMAX Mode
is "Off".
IMAX Bass
Feeding
On
Set the route for the bass component of the audio.
"On": The bass component of each channel is
output according to the crossover settings (
p159)
"Off": Only the LFE signal is output.
• This cannot be selected when the "IMAX User
Setting" is "Auto".
IMAX LFE Level 0 dB You can set the volume for the LFE when IMAX
signals are being input. Select "–∞ dB" or a value
between "0 dB" and "-20 dB".
• This cannot be selected when the "IMAX User
Setting" is "Auto".