Owner's Manual

182
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Output Zone Main Select the zone where you want to listen to the
music.
"Main": Outputs audio only to the main room
(where this unit is located).
"Zone 2": Outputs audio only to the separate room
(ZONE 2).
"Main/Zone 2": Outputs audio to both the main
room and separate room.
"Zone 3": Outputs audio only to the separate room
(ZONE 3).
"Main/Zone 3": Outputs audio to both the main
room and separate room (ZONE 3).
"Zone 2/Zone 3": Outputs audio to both the
separate rooms (ZONE 2 and ZONE 3).
"Main/Zone 2/Zone 3": Outputs audio to the main
room and both separate rooms (ZONE 2 and
ZONE 3).
• To use this function, set "Input Selector"
beforehand.
Preset Volume Main:
Last
Zone 2:
Last
Zone 3:
Last
You can set the volume beforehand for playing
back the Sonos Connect. You can set volumes
for the main room (where this unit is located) and
separate room (ZONE 2 or ZONE 3) respectively.
Select a value from "Last" (Volume level before
entering standby mode), "Min", "0.5" to "99.5" and
"Max".
• To use this function, set "Input Selector"
beforehand.
7. Multi Zone
 1. Zone 2
Change the settings for Zone 2.
Setting Item Default Value Setting Details
Output Level Fixed Select whether to adjust the volume on the premain
amplier in the separate room or on this unit when
outputting to Zone 2.
"Fixed": Adjust on the pre-main amplier in the
separate room
"Variable": Adjust on this unit
Maximum Volume Off Set the maximum value for Zone 2 to prevent the
volume from becoming too loud. Select a value
from "Off", and "50" to "99".
(When "3. Audio Adjust" - "Volume" - "Volume
Display" is set to "Absolute")
Power On Volume Last Set the Zone 2 volume level of when the unit is
turned on. Select a value from "Last" (Volume level
when the unit was turned off), "Min", "0.5" to "99.5"
and "Max". (When "3. Audio Adjust" - "Volume" -
"Volume Display" is set to "Absolute")
• You cannot set a higher value than that of
"Maximum Volume".
 2. Zone 3
Change the settings for Zone 3.
Setting Item Default Value Setting Details
Output Level Fixed Select whether to adjust the volume on the premain
amplier in the separate room or on this unit when
outputting to Zone 3.
"Fixed": Adjust on the pre-main amplier in the
separate room
"Variable": Adjust on this unit