Owner's Manual

En-23
Listening to the Radio
With the built-in tuner, you can enjoy AM and FM radio
stations.
1
Use the receiver’s [Input] selector, or the
remote controller’s Input Selector buttons
to select AM or FM.
In this example, FM has been selected.
(Actual display depends on the country.)
2
Press the [Tuning Mode] button so that the
AUTO indicator appears or disappears from
the display.
Auto Tuning
To activate this mode, press the [Tuning Mode]
button to turn on the “AUTO” indicator. In this
mode, you will receive the broadcast in stereo
sound.
Manual Tuning
To activate this mode, press the [Tuning Mode]
button to turn off the “AUTO” indicator. In this
mode, you will receive the broadcast in monaural
sound.
3
Press the Tuning [] or [] button.
You can also use the remote controller’s arrow
[]/[] buttons to tune the radio.
Auto Tuning
Searching stops when a station is found.
Manual Tuning
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the
frequency one step at a time.
The North American model changes FM frequency in
0.2 MHz (or 0.05 MHz) steps, 10 kHz (or 9 kHz) steps
for AM. For other models it’s 0.05 MHz steps for FM
and 9 kHz (or 10 kHz) steps for AM.
Tuning to Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
■ Tuning into Stations by Frequency
You can tune to AM and FM stations directly by entering
the appropriate frequency.
1
Press the remote controller’s [ D.TUN ] button.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons
to enter the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5.
Tuning F/H
Tuning ModeInput
D.TUN
&/(
Number
buttons
Listening to AM/FM Stations
Band Frequency
AUTO indicator
TUNED FM STEREO