Owner's Manual
Table Of Contents
- Front Panel
- Step 1: Connections
- Step 2: Initial Setup
- Step 3: Playing Back
- Details on AM/FM reception
- Playing Music Files on a USB Storage Device
- Listening to Internet Radio
- Playing Music with DLNA
- Playing Music Files in a Shared Folder
- Operating Music Files with the Remote Controller
- Using the Listening Modes
- Advanced Settings (Setup Menu)
- Operating Other Components with the Remote Controller
- Advanced speaker connections
- Connecting and Operating Onkyo RI Components
- Control Function between the Unit and External Component
- Firmware Update
- Troubleshooting
- Reference Information
Step 3: Playing Back
En-19
6 Multi-zone
You can listen to audio in a room (called Zone 2) other than
the one where this unit is located (called the main room)�
Sources you can playback
● External players (1)
● NET (2)
● Bluetooth
● AM/FM Radio
1 Only analog audio signals can be output to Zone 2�
2 DSD and Dolby TrueHD audio signals cannot be output to Zone 2�
Important: Connection with external players
To listen to a player in Zone 2, you must connect using an
RCA cable� Some players may require analog audio output
setting�
AUDIO
OUT
Making Multi-zone Connection
There are the following two methods of connection:
a� Connecting with a pre-main amplifier or a power amplifier
in a separate room
b� Connecting with speakers in a separate room
a� Connecting with a pre-main amplifier in a
separate room
It is possible to play 2 ch source in a separate room while
7�1 ch source is being played in the main room�
Connect the PRE/LINE OUT ZONE2 jacks of the unit and
the line-in jacks of the pre-main amplifier in a separate
room with an RCA cable�
Main room
Zone 2
● Settings are required in order to control volume and
sound quality on this unit� To adjust it with the unit, press
Receiver and then Setup on the remote controller,
select "3 Audio Adjust" - "Multi Zone" - "Zone 2 Out"
and set the setting to "Variable"� If you connect a power
amplifier, be sure to make the setting and adjust the
volume on this unit�
b� Connecting with speakers in a separate
room
Connect the speakers in another room to the SPEAKERS
ZONE2 jacks of the unit using speaker cables� Note that
5�1 ch will be the maximum () in the main room during
Zone 2 playback� No sound will be output from the back
speakers and height speakers�
¼ In this case, the Dolby Atmos listening mode cannot be selected�
Main room
Zone 2
These settings are required: After connecting
the speakers, press
Receiver and then Setup
on the remote controller, select "2� Speaker" -
"Configuration" and set "Powered Zone2" to "Yes"�