Owner's Manual
Table Of Contents
- Front Panel
- Step 1: Connections
- Step 2: Initial Setup
- Step 3: Playing Back
- Details on AM/FM reception
- Playing Music Files on a USB Storage Device
- Listening to Internet Radio
- Playing Music with DLNA
- Playing Music Files in a Shared Folder
- Operating Music Files with the Remote Controller
- Using the Listening Modes
- Advanced Settings (Setup Menu)
- Operating Other Components with the Remote Controller
- Advanced speaker connections
- Connecting and Operating Onkyo RI Components
- Control Function between the Unit and External Component
- Firmware Update
- Troubleshooting
- Reference Information

Advanced Settings (Setup Menu)
En-30
2� Speaker
Allows you to change the speaker configuration such as presence or not of subwoofer,
crossover frequency, and so on� Settings are automatically configured if you use the
Automatic Speaker Setup�
This setting cannot be selected if headphones are connected or audio is output from the
speakers of the TV�
Configuration
You can change the number of speaker channels connected, the type of front speaker
connection, the height speaker type, and other speaker settings�
Setting Item Default Value Setting Details
Speaker Channels 7�1 ch Select "2�1 ch", "3�1 ch", "4�1 ch", "5�1 ch", "6�1 ch",
"7�1 ch", "2�1�2 ch", "3�1�2 ch", "4�1�2 ch", or
"5�1�2 ch" to suit the number of speaker channels
connected�
Subwoofer Yes Set whether a subwoofer is connected or not�
"Yes": When subwoofer is connected
"No": When subwoofer is not connected
Height Speaker Front High Set the speaker type if height speakers are
connected to the BACK or HEIGHT terminals�
Select "Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)", or
"Dolby Speaker (Surr)" according to the connected
speaker type and location�
● If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels�
Bi-Amp No Set whether your front speaker connection is bi-
amp�
"No": When front speakers are connected in a
normal manner
"Yes": When front speakers are bi-amp connected
● If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels�
Setting Item Default Value Setting Details
Powered Zone 2 No Set the connection of speakers to Zone 2 speaker
terminals�
"Yes": When speakers are connected to ZONE2
speaker terminals
"No": When speakers are not connected to ZONE2
speaker terminals
● This item will be set to "No" when "Bi-Amp" is set
to "Yes"�
Crossover
Allows you to change speaker configurations, such as crossover frequency� Settings are
automatically configured if you use the Automatic Speaker Setup� Audio will not be output
while you are making this setting�
Setting Item Default Value Setting Details
Front 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Full Band" and the low
pitched range of the other channels will be output
from the front speakers� Refer to the instruction
manual of your speakers to make the setting�
Center 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
● "Full Band" can be selected only when "Front" is
set to "Full Band"�
● If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�