Owner's Manual

Table Of Contents
Advanced Settings (Setup Menu)
En-31
Setting Item Default Value Setting Details
Height 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
"Full Band" can be selected only when "Front" is
set to "Full Band"�
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
Surround 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
"Full Band" can be selected only when "Front" is
set to "Full Band"�
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
Back 100 Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel�
"Full Band": Full band will be output�
This cannot be selected in the following
conditions�
The setting for "Configuration" - "Bi-Amp" is
"Yes"
"Configuration" - "Powered Zone 2" is set to
"Yes" and ZONE 2 is on
"Full Band" can be selected only when
"Surround" is set to "Full Band"�
If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels�
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises� The
low-pass filter will be effective only on sources with
LFE channel�
The value from "80Hz" to "120Hz" can be set�
"Off": Do not use this function
Setting Item Default Value Setting Details
Double Bass On This can only be selected when "Configuration" -
"Subwoofer" is set to "Yes" and "Front" is set to "Full
Band"�
Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer
"On": Bass output will be boosted�
"Off": Bass output will not be boosted�
The setting will not automatically be configured
even if you performed the automatic speaker
setup�
Distance
Set the distance from each speaker to the listening position� Settings are automatically
configured if you use the automatic speaker setup�
Setting Item Default Value Setting Details
Unit feet/meters Specify the unit of distance for configuring
settings�
"feet": When setting in feet (0�1 ft to 30�0 ft, in
increments of 0�1 ft)
"meters": When setting in meters (0�03 m to
9�00 m, in increments of 0�03 m)
Front Left 12�0ft/3�60m Specify the distance between each speaker and
the listening position�
Center 12�0ft/3�60m Specify the distance between each speaker and
the listening position�
Front Right 12�0ft/3�60m Specify the distance between each speaker and
the listening position�
Height Left 9�0ft/2�70m Specify the distance between each speaker and
the listening position�
This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Height Right 9�0ft/2�70m Specify the distance between each speaker and
the listening position�
This setting cannot be changed if
"Configuration" - "Powered Zone 2" is set to
"Yes" and Zone2 is set to on�
Surround Right 7�0ft/2�10m Specify the distance between each speaker and
the listening position�