Owner's Manual
Table Of Contents
- Front Panel
- Step 1: Connections
- Step 2: Initial Setup
- Step 3: Playing Back
- Details on AM/FM reception
- Playing Music Files on a USB Storage Device
- Listening to Internet Radio
- Playing Music with DLNA
- Playing Music Files in a Shared Folder
- Operating Music Files with the Remote Controller
- Using the Listening Modes
- Advanced Settings (Setup Menu)
- Operating Other Components with the Remote Controller
- Advanced speaker connections
- Connecting and Operating Onkyo RI Components
- Control Function between the Unit and External Component
- Firmware Update
- Troubleshooting
- Reference Information
Advanced speaker connections
En-53
Advanced speaker connections
Connecting Bi-amp Speakers
It is possible to connect speakers supporting bi-amping to
improve quality of the bass and treble� Up to 5�1 ch will be
played in bi-amping�
¼ Connections
1� Connect as below using the FRONT terminals and
BACK or HEIGHT terminals�
Tweeter
(high pitched tone)
Woofer
(low pitched tone)
Front R Front L
2� Turn the unit on and make the bi-amping setting�
1 After pressing Receiver on the remote controller,
press Setup�
2 With the cursors, select "2� Speaker" -
"Configuration" - "Bi-Amp"�
3 Select "Yes" with the cursors�
● Before bi-amping, be sure to remove the short-
circuit connector that connects the tweeter (treble)
jack and the subwoofer (bass) jack�
● Use speakers supporting bi-amping only� For
details, refer to the speakers' instruction manual�