Owner's Manual

16
Step 3: Playing Back
Performing Multi-zone Playback
1.
Press Zone2 on the remote controller, point the
remote controller at the unit and press zReceiver.
"Z2" stays lit on the main unit display and the multi-zone
function is enabled. (Zone 2 is now on.)
2. Press Zone2 on the remote controller again and
press Input Selector of the input to be played in a
separate room.
 If you turn the unit to standby during multi-zone
playback, the Z2 indicator is dimmed and the
playback mode is switched to playback in a separate
room only. Performing steps 1 and 2 while the unit
is in standby also switches the playback mode to
playback in a separate room only. To play the same
source in the main room and separate room, hold
down Zone2 for approximately 3 seconds.
To control on the main unit: Press Zone2 and within

played in a separate room. To play the same source in the
main room and separate room, press Zone2 twice.
To turn off the multi-zone function: Press Zone2 on the
remote controller and press zReceiver. Alternatively press
Off on the main unit.
To adjust the volume: Press Zone2 on the remote
controller and adjust with VOL S / T . Alternatively press Zone2
Level S / T on the main unit.
To mute temporarily: Press Zone2 and then press Muting
on the remote controller.
To adjust the sound quality for the separate room: It
is necessary to make appropriate settings to enable this
function. Press Home on the remote controller and select
"Setup" - "7. Hardware Setup" - "Multi Zone" - "Zone 2
Out", and set its value to "Variable". As for the operation,
press Zone 2 on the main unit and press Tone several
times to display "Bass", "Treble" or "Balance" on the main
unit display. Display the desired setting on the display and

 If Zone 2 is on, power consumption during standby
becomes larger than normal.
 While Zone 2 is on, the RI linked system function
(interlink between Onkyo components) is disabled.
 Pressing Input Selector on the remote controller while
you are using the remote controller for Zone 2 will switch
the controlled target to the main room. To control Zone 2
again, press Zone2 to select the Zone 2 control mode.