Owner's Manual

Advanced Operations
En-72
Adjusting the Volume for Zones
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Muting Zones
■ Operating on the remote controller
Tip
• To unmute, press Zone2 or Zone3 followed by Muting again.
Zones can also be unmuted by adjusting the volume.
Adjusting the Tone and Balance of Zone 2
Note
• Only analog input sources are output by the ZONE 2/3
PRE/LINE OUT, FRONT WIDE/ZONE 2 L/R and FRONT
HIGH/ZONE 3 L/R terminals. Digital input sources are not
output. If no sound is heard when an input source is selected,
verify that the source is connected to an analog input.
• You cannot select different AM or FM radio stations for your
main room and Zone 2/3. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2/3.
• When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2/3.
• When Zone 2/3 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• While Zone 2/3 is on, u functions will not work.
• When setting the AV receiver to standby mode while Zone 2/3 is
active, the Z2 or Z3 indicator is dimly lit.
• The Zone 2 level, balance, and tone functions have no effect on
the ZONE 2 PRE/LINE OUT jacks when the “Zone 2 Out”
setting is set to “Fixed” (➔ page 66).
• The Zone 3 volume function has no effect on ZONE 3
PRE/LINE OUT when the “Zone 3 Out” setting is set to
“Fixed” (➔ page 66).
The 12V triggers A, B, and C can be used to turn on 12V
trigger-capable components automatically when they are
selected as the input source. The triggers can be set so that
they activate themselves once a connected component is
selected as the input source for the main room, Zone 2,
Zone 3, or any combination of rooms. When triggered, the
output from a 12V TRIGGER OUT goes high (+12 volts
and 150 milliamperes max. at 12V TRIGGER OUT A;
+12 volts and 25 milliamperes max. at 12V TRIGGER
OUT B and C).
See “12V Trigger A/B/C Setup” (➔ page 65).
Hookup
• Use a miniplug cable to connect the AV receiver’s 12V
TRIGGER OUT A, B, or C jack to the 12 V trigger
input of a connected component.
1
Press Zone2 or Zone3.
2
Use VOL q/w.
1
Press Zone 2 or Zone 3 (the Z2/Z3 indicator on the
display flashes).
2
Use Master Volume control within 8 seconds.
1
Press Zone2 or Zone3, and then press Muting.
1
On the AV receiver, press Zone 2.
2
Press the AV receiver’s Tone repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use – or + to adjust the bass, treble or balance.
• You can boost or cut the bass or treble from –10 dB
to +10 dB in 2 dB steps.
• You can adjust the balance from 0 in the center to
+10 dB to the right or +10 dB to the left in 2 dB
steps.
Using the 12V Triggers