Instruction Manual AV Receiver DTM-5.3

26
Using Tape 2 Monitor
Unless the component connected to the TAPE 2 connectors is used,
the indicator in the main unit’s display should not
be lit; otherwise, the sound from other sources will not be heard.
If a 3-head tape deck is connected to the TAPE 2 connectors, you
can use the Tape 2 Monitor to monitor the recording.
Notes:
• Even when Tape 2 is not selected as the source (the
indicator is not lit), the source signal is still sent
to the TAPE 2 output.
• If you select a different input source while listening to the Tape
2 Monitor sound, the indicator flashes for a few
seconds. However, the audio signal does not change.
Monitoring during recording
You can monitor the source signal through the speakers or
headphones when Tape 2 Monitor is turned off.
If the indicator in the display is not lit, the sound
from the source should be audible. If a 3-head tape deck connected
to the TAPE 2 connectors is used for recording, press either the
Tape 2 button on the remote controller or the Tape 2 Monitor but-
ton on the main unit. “TAPE 2” will appear in the display for a few
seconds: the indicator will light up and the sound
you just recorded will be audible.
To return to listening to the source sound, press either the Tape 2
button on the remote controller or the Tape 2 Monitor button on the
main unit. The indicator turns off.
Using a graphic equalizer
1 Connect the graphic equalizer to the TAPE 2 connectors on
the rear panel of the DTM-5.3.
2 If a second tape deck is used, connect it to the tape deck con-
nectors on the graphic equalizer.
3 Press the Tape 2 button on the remote controller or the
Tape 2 Monitor button on the main unit.
The indicator on the main unit’s display lights
up.
4 Follow the operating instructions for the graphic equalizer.
To record an equalized signal, use the tape deck connected to
the equalizer.
Standby/On
Speakers
A
B
Phones
Bass
Treble Balance
L
R
Master Volume
Video
Tape 2
Monitor
Tape 1
FM
AM Phono CDDVD
Zone 2 Off
Memory
Clear
Character
Direct Tuning
FM Mode
Display
Standby
DTM
-
5.3
1 ABC 2 DEF 3 GHI
4 JKL
5 MNO 6 PQR
7 STU 8 VWX 9 YZ
-
Direct Tuning 0
/
10
/
Scan
Tape 2 Monitor
Tape 2
T-2 MONITOR
T-2 MONITOR
T-2 MONITOR
T-2 MONITOR
T-2 MONITOR
T-2 MONITOR
T-2 MONITOR
Tape 2
Monitor
Remote controller
or
T-2 MONITOR
DTM-5.3
Recording
AMP.
PlaybackPlayback
or Graphic Equalizer
Tape deck (TAPE 2)
CD player, etc.
T-2 MONITOR
T-2 MONITOR
Tape 2
Monitor
T-2 MONITOR
Remote controller
or