Owner's Manual

Connections

Connecting the AV Receiver

Connecting the Speaker Cables

The following illustration shows which speaker should be connected to each pair of terminals.

■ 7.2-channel playback

Connect your Power amplifier’s analog audio input jacks to the AV receiver’s SURROUND BACK L/R PRE OUT

jacks with audio cables.

If you’re using only one surround back speaker, connect it to the SURROUND BACK L PRE OUT terminals.

Tip

• You can specify whether surround back speakers are connected in the “Speaker Configuration” menu (➔ page 41) or during

Audyssey 2EQ

Room Correction and Speaker Setup (➔ page 29).

■ Screw-type speaker terminals

Strip 1/2" to 5/8" (12 to 15 mm) of insulation from

the ends of the speaker cables, and twist the bare

wires tightly, as shown.

■ Banana Plugs (North American models)

• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.

• Do not insert the speaker code directly into the center hole of the speaker terminal.

Connecting Your Speakers

AUDIO

INPUT

Front left Center

Surround

right

Front right

Surround

back right

Surround

back left

Surround

left

Power amplifier

1/2" to 5/8" (12 to 15 mm)