Owner's Manual

Changing the Speaker Setup Manually

You can manually make changes to the settings found

during Audyssey 2EQ Room Correction and Speaker

Setup.

See also:

• “Speaker Configuration” (➔ page 41)

• “Speaker Distance” (➔ page 42)

• “Level Calibration” (➔ page 43)

• “Equalizer Settings” (➔ page 43)

Note

• Please note that THX recommends any THX main speakers be

set to “80Hz(THX)”. If you set up your speakers using

Audyssey 2EQ Room Correction and Speaker Setup, please

make sure manually that any THX speakers are set to

“80Hz(THX)” crossover (➔ page 41).

• Sometimes due to the electrical complexities of subwoofers and

the interaction with the room, THX recommends setting the

level and the distance of the subwoofer manually.

• Sometimes due to interaction with the room, you may notice

irregular results when setting the level and/or distance of the

main speakers. If this happens, THX recommends setting them

manually.

Using a Powered Subwoofer

If you’re using a powered subwoofer and it outputs very

low-frequency sound at a low volume level, it may not be

detected by Audyssey 2EQ Room Correction and Speaker

Setup.

If the “Subwoofer” appears on the “Review Speaker

Configuration” screen as “No”, increase the subwoofer’s

volume to the half-way point, set it to its highest crossover

frequency, and then try running Audyssey 2EQ Room

Correction and Speaker Setup again. Note that if the

volume is set too high and the sound distorts, detection

issues may occur, so use an appropriate volume level. If

the subwoofer has a low-pass filter switch, set it to Off or

Direct. Refer to your subwoofer’s instruction manual for

details.