Owner's Manual

Connections
En-16
With u (Remote Interactive), you can use the following
special functions:
System On/Auto Power On
When you start playback on a component connected via
u, while the AV receiver is on standby, the AV
receiver will automatically turn on and select that
component as the input source.
Direct Change
When playback is started on a component connected via
u, the AV receiver automatically selects that
component as the input source.
Remote Control
You can use the AV receiver’s remote controller to
control your other u-capable Integra/Onkyo
components, pointing the remote controller at the AV
receiver’s remote control sensor instead of the
component. You must enter the appropriate remote
control code first ( page 69).
Note
•Use only u cables for u connections. u cables are supplied
with Integra/Onkyo components.
Some components have two u jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional u-capable components.
Connect only Integra/Onkyo components to u jacks.
Connecting other manufacturer’s components may cause a
malfunction.
Some components may not support all u functions. Refer to the
manuals supplied with your Integra/Onkyo components.
While Zone 2 is on, the System On/Auto Power On and Direct
Change u functions do not work.
Connecting Integra/Onkyo RI
Components
1
Make sure that each Integra/Onkyo component is
connected with an analog audio cable (connection
H
in the hookup examples) ( page 15).
2
Make the u connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display ( page 39).
LR
ANALOG
AUDIO OUT
LR
ANALOG
AUDIO OUT
e.g., cassette tape deck
RI Dock