Owner's Manual

Advanced Operations
En-62
Zone 2
In addition to the main listening room, you can also enjoy
playback in another room, or as we call Zone 2. And, you
can select a different source for each room.
Connecting the Zone Speakers to an
Additional Amplifier
This setup allows 5.1-channel playback in your main
listening room and 2-channel stereo playback in Zone 2.
Note
• With the default settings, the Zone 2 volume must be set on the
Zone 2 amplifier. If your Zone 2 amplifier has no volume control,
change the setting so that you can set the Zone 2 volume on the
AV receiver. See “Multi Zone” (➔ page 58).
See “Multi Zone” (➔ page 58).
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press Zone2 on the remote
controller first.
Making Zone 2 Connections
IN
R
L
Main room
TV
Zone 2
AV receiver
Receiver/
integrated amp
Setting the Zone 2 Out
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button within
8 seconds.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room’s, press
Zone 2 twice. “Z2 Sel: Source” appears on the AV
receiver’s display.
2
To turn off Zone 2, press Off.
The zone is turned off.
Tip
The corresponding trigger output goes low (0 volts).
Input selector buttons
Zone 2
Off
Tone
–, +
Zone 2 Level q/w
1
Press Zone2, then point the remote controller at
the AV receiver and press 8Receiver.
Zone 2 turns on, the Z2 indicator lights on the AV
receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2, press Zone2,
followed by an Input Selector button.
3
To turn off Zone 2, press Zone2, followed by
8Receiver.
The zone is turned off.
Tip
The corresponding trigger output goes low (0 volts).
8Receiver
Zone2
Input
Selector
VOLq/w
Muting