Owner's Manual

Advanced Settings
24
Setting Item Default Value Setting Details
Back 100Hz Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• In the following cases, the setting will be set to
"None":
– "Surround" is set to "None".
– "Front Speakers Type" is set to "Bi-Amp".
– "Powered Zone 2" is set to "Yes" and also
Zone2 is set to on.
• "Full Band" cannot be set unless "Surround" is
set to "Full Band".
Back Channel 2ch Select the number of channels of the connected
surround back speaker.
"1ch": When one speaker is connected (Connect to
the BACK or HEIGHT L terminal)
"2ch": When two speakers are connected
• The setting cannot be changed if "Back" is set to
"None".
Height None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting bass frequencies for
each channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
• In the following cases, the setting will be set to
"None":
– "Surround" is set to "None".
– "Front Speakers Type" is set to "Bi-Amp".
– "Powered Zone 2" is set to "Yes" and also
Zone2 is set to on.
• "Full Band" cannot be set unless "Front" is set to
"Full Band".
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
Set a frequency from "80Hz", "90Hz", "100Hz" and
"120Hz".
"Off": Do not use this function
Setting Item Default Value Setting Details
Double Bass ----- Boost bass output by feeding bass sounds from
the front left and right, and center speakers to the
subwoofer.
"On": Bass output will be boosted.
"Off": Bass output will not be boosted.
• The setting will not automatically be configured
even if you performed the automatic speaker
setup.
• If "Subwoofer" is set to "No" or if "Front" is set to
other than "Full Band", the setting will be fixed to
"-----".
Speaker Distance
Set the distance from each speaker to the listening position. Settings are automatically
configured if you use the automatic speaker setup.
Setting Item Default Value Setting Details
Unit feet/meters Specify the unit of distance for configuring
settings.
"feet": When setting in feet (0.1 ft to 30.0 ft, in
increments of 0.1 ft)
"meters": When setting in meters (0.03 m to 9.00
m, in increments of 0.03 m)
Front Left 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
Center 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
Front Right 12.0 ft/3.60 m Specify the distance between each speaker and
the listening position.
Surround Right 7.0 ft/2.10 m Specify the distance between each speaker and
the listening position.
Back Right 7.0 ft/2.10 m Specify the distance between each speaker and
the listening position.
Back Left 7.0 ft/2.10 m Specify the distance between each speaker and
the listening position.
Surround Left 7.0 ft/2.10 m Specify the distance between each speaker and
the listening position.