Owner's Manual

49
Advanced Connection
Advanced Connection
Bi-Amping
It is possible to connect speakers supporting bi-amping to
improve quality of the bass and treble. Up to 5.2 ch will be
played in bi-amping.

Connections
1.
Connect as below using the FRONT terminals and
BACK or HEIGHT terminals.
Front R Front L
Tweeter (treble)
Woofer (bass)
2.
Turn the unit on and make the bi-amping setting.
1
After pressing RCV, press Home on the remote
controller.
2
Select "Setup" with the cursors and press Enter.
3
With the cursors, select "2.|Speaker Setup" -
"Speaker Settings" - "Front Speakers Type".
4
Select "Bi-Amp" with the cursors.
r Before bi-amping, be sure to remove the short-
circuit connector that connects the tweeter (treble)
terminal and the woofer (bass) terminal.
r Use speakers supporting bi-amping only. For
details, refer to the speakers' instruction manual.
Connecting a Power Amplifier
You can connect a power amplifier to the unit and use the
unit as a pre-amplifier in order to produce a large volume
that cannot be output with the unit only. Connect the
speakers to the power amplifier. For details, refer to the
power amplifier's instruction manual.

Connections
1.
Connect as below using the PRE OUT terminals.
Power amplifier
r Set the unconnected channels to "None" in "Speaker
Configuration".
– After pressing RCV, press Home on the remote
controller. Select "Setup" with the cursors and press
Enter. Then select "2.|Speaker Setup" - "Speaker
Configuration" and set the unconnected channels to
"None".