Owner's Manual

Step 1: Connections
En-7
'
Subwoofer with built-
in power amplifier
&
Surround R
8FH
Right back
Or right height
79G
Left back
Or left height
%
Surround L
$
Center
#
Front R
"
Front L
A speaker
configuration
where only one
back speaker is
connected is not
supported�
and the other type is designed to be integrated with normal
speakers� Dolby Enabled Speakers placed with their
diaphragms facing toward the ceiling create higher effect
in the Dolby Atmos and Dolby Surround listening modes
by providing sounds echoing off the ceiling� You can select
(g)(h) or (i)(j) on the unit� For connection with the unit,
use the SPEAKERS BACK or HEIGHT terminals�
When playing Dolby Atmos, the speakers required depend
on how you have setup your back speakers or height
speakers� The following shows combinations of speakers
for reproducing Dolby Atmos�
1 Back

2 Front High
 
3 Rear High
 
4 Top Front
 
5 Top Middle
 
6 Top Rear
 
7 Dolby Enabled Speaker (Front)
 
8 Dolby Enabled Speaker (Surround)

Connection
pattern
Front
Center
Surround
Back or Height
: Required, : Optional
 Connection of a subwoofer is optional�
Important: (North American models)
Connect speakers with 6 Ω to 16 Ω impedance. Using a
speaker with less impedance than the supported value
may result in failure�
Important: (Australian models)
Connect speakers with 4 Ω to 16 Ω impedance. You
have to change the setting if any of the speakers
have 4 Ω or more to less than 6 Ω impedance. Using
a speaker with less impedance than the setting may
result in failure� You can set up by viewing the guidance
displayed on the TV screen� Select the item with the
cursor buttons of the remote controller and press Enter
to confirm your selection� To return to the previous
screen, press Return� Press
Receiver and then
Setup on the remote controller� Select "2� Speaker" -
"Configuration" - "Speaker Impedance" and change the
default value from "6ohms" to "4ohms"�