Owner's Manual

Advanced Settings
28
Setting Item Default Value Setting Details
Surround Left 7.0 ft/2.10 m Specify the distance between each speaker and the
listening position.
Subwoofer 12.0 ft/3.60 m Specify the distance between each speaker and the
listening position.
Height Left 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
Height Right 9.0 ft/2.70 m Specify the distance between each speaker and the
listening position.
• When the speaker is set to "No" or "None" in "Speaker Configuration", the settings for "Speaker
Distance" cannot be changed.
• Default values vary depending on the regions.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value Setting Details
Front Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Center 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Front Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Surround Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Back Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Back Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Setting Item Default Value Setting Details
Surround Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Subwoofer 0 dB Select a value between "-15 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Height Left 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
Height Right 0 dB Select a value between "-12 dB" to "+12 dB". A
test tone will be output each time you change the
value. Select the desired level.
• In the following cases, the settings for "Level Calibration" cannot be changed:
– The speaker is set to "No" or "None" in "Speaker Configuration".
– Mute (MUTING) is set.
• The test tone is output at the standard level for THX, which is 0 dB (absolute volume setting 82). If you
normally listen at volume settings below this, be careful because the test tone will be much louder.
• If you are using a handheld sound pressure level meter, adjust the level of each speaker to 75 dB
SPL at the listening position, measured in C-Weighting and slow reading.