Owner's Manual
Advanced Settings
50
Firmware Update
Setting Item Default Value Setting Details
Update Notice Enable Availability of a firmware update will be notified
via network.
"Enable": Notify updates
"Disable": Do not notify updates
Version – The current firmware version will be displayed.
Update via NET – Press Enter to select when you want to update
the firmware via network.
• You will not be able to select this setting if you
do not have Internet access or there is nothing
to update.
Update via USB – Press Enter to select when you want to update
the firmware via USB.
• You will not be able to select this setting if
a USB storage device is not connected or
there is nothing to update in the USB storage
device.
• Wait for a while if "Firmware Update" cannot be selected. It will appear when the network function is
started up.
Initial Setup
You can make the initial setup from the setup menu.
• Wait for a while if "Initial Setup" cannot be selected. It will appear when the network
function is started up.
• Setting is not possible if "Monitor Out" is set to "SUB".
8.Remote Controller Setup
Setting Item Default Value Setting Details
Remote ID 1 Select an ID for the unit's remote controller from
"1", "2", and "3" to prevent interference between
the unit and other Integra/Onkyo components
that are installed in the same room. After
changing the ID on the main unit, change the
ID on the remote controller accordingly with the
following procedure.
1. While holding down Receiver, press Q Setup
for about 3 seconds until the Receiver button
stays lit.
2. With the number buttons, press one of 1, 2,
and 3. The Receiver button flashes twice.
Remote Mode Setup – Input and register the remote controller code of
other devices.
• For registration of the remote control code,
refer to "Operating Other Components Using
Remote Controller".
9.Lock Setup
Setting Item Default Value Setting Details
Setup Unlocked The Setup menu will be locked to protect the
settings.
"Locked": The menu is locked.
"Unlocked": The menu is unlocked.