Owner's Manual

64
Listening to the Radio—Continued
Changing the PIN Number
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [Enter].
The Hardware Setup menu appears.
3
Use the Up and Down [q]/[w] but-
tons to select “3. Tuner”, and
then press [Enter].
The Tuner screen appears.
4
Use the Up and Down [q]/[w] but-
tons to select “SIRIUS Parental
Lock”, and then press [Enter].
The SIRIUS Parental Lock screen appears.
Note:
If the SAT Radio Mode is set to “None”
(see page 58), the “SIRIUS Parental
Lock” item is not available.
7. Hardware Setup
1. Remote ID
2. Zone 2
3. Tuner
4. HDMI
5. Network
7–3. Tuner
FM/AM Frequency Step
SAT Radio Mode
Antenna Aiming
SURIUS Parental Lock
200kHz/10kHz
SIRIUS
->
->
SIRIUS Parental Lock
Enter Code
0 123456789
5
Use the Left and Right [e]/[r]
buttons to select a number on the
screen, and then press [Enter].
Repeat this for each of the four
digits in the PIN number.
If you’re entering the PIN number for
the very first time, the PIN is stored,
and the following screen appears.
If you’ve already set a PIN number, you
must enter the correct PIN to get to this
screen. If you enter the wrong PIN, the
message “Wrong Code!” appears and
you’ll have to enter the PIN again.
Note:
The SIRIUS Parental Lock cannot be
set unless the AV receiver and the Siri-
usConnect receiver are connected.
6
Use the Up and Down [q]/[w] but-
tons to select “Edit Code”, and
then press [Enter].
The New Code screen appears.
7
Use the Left and Right [e]/[r]
buttons to select a number on the
screen, and then press [Enter].
Repeat this for each of the four
digits in the new PIN number.
The Confirm screen appears.
SIRIUS Parental Lock
Edit Code
Parental Lock
->
SIRIUS Parental Lock
New Code
0 123456789
SIRIUS Parental Lock
Confirm
0 123456789
DTR-30.1_En_A.book 64 ページ ２００９年４月９日 木曜日 午後１時３０分