Owner's Manual

59
En
Speaker Levels
Subwoofer Level
` –15dB to 0dB
to +12dB in 1 dB steps.
Center Level
` –12dB to 0dB
to +12dB in 1 dB steps.
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to standby. To save the setting you made
here, go to “Level Calibration” ( page 46) before
setting the AV receiver to standby.
Note
You cannot use this function while the AV receiver is muted.
Speakers that are set to “No” or “None” in “Speaker
Configuration” ( page 45) cannot be adjusted.
Audyssey
Audyssey
See “Audyssey” in “Source Setup” ( page 49).
Dynamic EQ
See “Dynamic EQ” in “Source Setup” ( page 49).
Dynamic Volume
See “Dynamic Volume” in “Source Setup” ( page 50).
Note
These technologies can be used when all the following
conditions are met:
Room Correction and Speaker Setup is completed. Note that
Audyssey” requires the “Audyssey 2EQ Full Calibration
method.
Any listening mode other than Direct is selected.
A pair of headphones is not connected.
The setting is stored individually for each input selector.
Late Night
Late Night
For Dolby Digital and Dolby Digital Plus sources, the
options are:
` Off
` Low:
Small reduction in dynamic range.
` High:
Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
` Auto
:
The Late Night function is set to “On” or “Off
automatically.
` Off
` On
Turn this setting on to reduce the dynamic range of Dolby
Digital material so that you can still hear quiet parts even
when listening at low volume levels—ideal for watching
movies late at night when you don’t want to disturb
anyone.
Note
The effect of the Late Night function depends on the material
that you are playing and the intention of the original sound
designer, and with some material there will be little or no effect
when you select the different options.
The Late Night function can be used only when the input source
is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.
The Late Night function is set to “Off” when the AV receiver is
set to standby. For Dolby TrueHD sources, it will be set to
Auto”.
Music Optimizer
Music Optimizer
` Off
` On
Turn this setting on to enhance the sound quality of
compressed music files. Use it with music files that use
“lossy” compression, such as MP3.
Note
The Music Optimizer function only works with PCM digital
audio input signals with a sampling rate below 48 kHz and
analog audio input signals. The Music Optimizer is disabled
when the Direct listening mode is selected.
The setting is stored individually for each input selector.
•The M.Opt indicator will light ( page 9).
Re-EQ
With the Re-EQ function, you can compensate a
soundtrack whose high-frequency content is too harsh,
making it more suitable for home theater viewing.
Re-EQ
` Off
` On
This function can be used with the following listening
modes: Dolby Digital, Dolby Digital Plus,
Dolby TrueHD, Multichannel, DTS, DTS-HD High
Resolution Audio, DTS-HD Master Audio, DTS Express,
DSD, Dolby EX, Dolby Pro Logic IIz Height, Dolby
PLIIx Movie, Neo:6 Cinema and 5.1-channel source +
Neo:6.
Re-EQ(THX)
` Off
` On
This function can be used with the following listening
modes: THX Cinema, THX Surround EX, and
THX Select2 Cinema.
Note
Settings for the Re-EQ function are kept in each listening mode.
In THX listening mode however, the setting will return to On
when the AV receiver is turned off.