Owner's Manual
Advanced Operations
En-69
See “Multi Zone” (➔ page 64).
■ Operating on the AV receiver
Tip
• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 44).
■ Operating on the remote controller
To control Zone 2/3, you must press Zone2 or Zone3 on
the remote controller first.
Adjusting the Volume for Zone 2/3
■ Operating on the remote controller
■ Operating on the AV receiver
If your Zone 2/3 speakers are connected to a receiver or
integrated amplifier in Zone 2/3, use its volume control to
adjust the volume.
Muting Zone 2/3
■ Operating on the remote controller
Tip
• To unmute, press Zone2 or Zone3 followed by Muting again.
Zone can also be unmuted by adjusting the volume.
Setting the Zone 2/3 Out
Controlling Multi Zone Components
1
To turn on Zone 2/3 and select an input source,
press Zone 2 or Zone 3 followed by an input
selector button within 8 seconds.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
To select the same source as the main room’s, press
Zone 2 or Zone 3 twice. “Z2 Sel: Source” or “Z3
Sel: Source” appears on the AV receiver’s display.
2
To turn off Zone 2/3, press Off for each Zone.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
Input selector buttons
Zone 2, Off
Zone 3, Off
Tone
Master Volume
–, +
1
Press Zone2 or Zone3, then point the remote
controller at the AV receiver and press 8Receiver.
Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
AV receiver’s display.
Tip
• The corresponding trigger output goes high (+12 V).
2
To select an input source for Zone 2/3, press Zone2
or Zone3, followed by an Input Selector button.
3
To turn off Zone 2/3, press Zone2 or Zone3,
followed by 8Receiver.
The zone is turned off.
Tip
• The corresponding trigger output goes low (0 volts).
8Receiver
Zone2
Zone3
Input
Selector
VOLq/w
Muting
1
Press Zone2 or Zone3.
2
Use VOL q/w.
1
Press Zone 2 or Zone 3(the Z2 or Z3 indicator on
the AV receiver’s display flash).
2
Use Master Volume control within 8 seconds.
1
Press Zone2 or Zone3 followed by Muting.