Owner's Manual

Step 1: Connections
En-11
3 Other connections
AM/FM antenna connections
Connect the antennas to listen to AM/FM broadcast� When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception�
AM loop antenna
(supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall�
(North American models)
(Australian models)
Assemble the AM loop antenna (supplied)�
Network connection
You can enjoy Internet radio, DLNA and AirPlay by
connecting the unit to LAN� The unit can be connected to
the router with an Ethernet cable or to the wireless LAN
router with Wi-Fi connection� In case of wired connection,
connect the Ethernet cable to the Ethernet port� See "4
Network Connection" of "Step 2: Initial Setup" for Wi-Fi
settings�
Internet radio
Router
NAS
Headphones connection
Connect stereo headphones with a standard plug (1/4
inch or ø 6�3 mm) to the Phones jack on the front panel�
Sound from the speakers will be off while you are using the
headphones�
● If you selected any other listening mode than Stereo,
Mono and Direct, connecting headphones will switch the
listening mode to Stereo�
Power cord
This unit includes a removable power cord� Connect the
power cord to AC INLET of the unit and then connect to
the outlet� Always disconnect the outlet side first when
disconnecting the power cord� When the unit is turned on, a
large instantaneous current may flow affecting functionality
of the computer and other devices, so it is recommended to
use a separate outlet�