Owner's Manual

Operating Other Components with the Remote Controller
En-52
Operating Other Components with
the Remote Controller
Functions of Remote Mode Buttons
You can control any other device than this unit by
programming a specified remote control code to a Remote
Mode button of the remote controller� Register a remote
control code to a desired Remote Mode button and press
it to enter the remote mode that allows you to operate the
corresponding device�
¼½ The Receiver and Zone2 buttons cannot be programmed�
Programming Remote Control Codes
¼ Searching in the Setup Menu
You can search a remote control code and register it to a
desired Remote Mode button in the unit's Setup menu�
1� After pressing Receiver on the remote controller, press
Setup�
2� With the cursors, select "7� Remote Controller" -
"Remote Mode" and press Enter�
3� With the cursors, select the Remote Mode button for
which you want to register a remote control code and
press Enter to display the subcategory selection screen�
4� With the cursors, select the target subcategory, and then
press Enter to display the brand name input screen�
5� Select a character with the cursors and press Enter�
Repeat it to enter the first three characters of the brand
name�
6� Select "Search" with the cursors and press Enter�
● After a search is done, the list of possible brand
names is displayed� If the brand name list is not
displayed, select "Not Listed" with the cursors and
press Enter to return to the brand name input screen
in step 5�
7� With the cursors, select the target brand name, and then
press Enter�
● When the brand name is specified, the remote
control code of the brand and how to register it will be
displayed on the TV screen�
8� Follow the guidance displayed on the TV screen�
9� If the component can successfully be operated with its
registered remote control code, select "OK" with the
cursors and press Enter�
● Only TV remote control codes can be entered for TV�
● Program a remote control code in accordance
with the input since each button also works as the
input selector� (For example, when the CD player
is connected to the CD jack, program the remote
control code for the CD player to CD)
● If the component cannot be operated, select "Try
Next Code" with the cursors and press Enter to
display another code�