Owner's Manual

36
First Time Setup —Continued
Notes:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Low-Pass Filter for the LFE Channel
With this setting, you can specify the cutoff frequency of
the LFE channel’s low-pass filter (LPF), which can be
used to filter out unwanted hum. The LPF only applies to
sources that use the LFE channel.
Notes:
• These settings cannot be changed while headphones
are connected or the multichannel DVD input is being
used.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Double Bass
With the Double Bass function, you can boost bass out-
put by feeding bass sounds from the front left, right, and
center to the subwoofer. This function can be set only if
the Subwoofer setting (step 4) is set to Yes, and the Front
setting (step 5) is set to Full Band in the Speaker Config-
uration on page 35.
Notes:
• These settings cannot be changed while headphones are
connected or the multichannel DVD input is being used.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Speaker Distance
With these settings, you can specify the distance from
each speaker to the listening position.
7
Use the Down [ ] button to
select “Surr,” and then use the
Left and Right [ ]/[ ] buttons to
select a crossover frequency.
If no surround left and right speakers
are connected, select None.
Note:
• Cannot select Full Band if Front
(step 5) is set to anything other than
Full Band.
Continue with step 8 of the “Low-Pass
Filter for the LFE Channel” setting.
8
Use the Down [ ] button to
select “LPF,” and then use the
Left and Right [ ]/[ ] buttons to
select a lowpass filter frequency.
The following low-pass filter frequen-
cies can be selected: 80Hz, 90Hz,
100Hz, 110Hz, or 120Hz.
Continue with step 9 of the “Double
Bass” setting on the next page.
9
Use the Down [ ] button to
select “D.Bass,” and then use the
Left and Right [ ]/[ ] buttons to
select:
On: Double Bass function on.
Bass from the front left and
right channels is also fed to
the subwoofer (default).
Off: Double Bass function off.
10
Press the [Setup] button.
Setup closes.
1
Measure and make a note of the
distance from each speaker to
the listening position.
2
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
DTR-4.9_En.book Page 36 Tuesday, April 15, 2008 5:13 PM