Owner's Manual

38
First Time Setup —Continued
Notes:
• The speaker levels cannot be adjusted while a pair of
headphones is connected or the AV receiver is muted.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow buttons.
Equalizer Settings
Here you can adjust the tone of individual speakers. To
set the volume of individual speakers, see page 37.
Notes:
• The front, center, and surround speakers can be
adjusted at 63Hz, 250Hz, 1000Hz, 4000Hz, and
16000Hz. The subwoofer can be adjusted at 25Hz,
40Hz, 63Hz, 100Hz, and 160Hz.
• While the Direct listening mode is selected, the equal-
izer settings have no effect.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
7
Press the [Setup] button.
Setup closes.
Don’t forget to turn down the volume if
you turned it up while setting the levels.
1
Press the [Receiver] Remote
Mode button, followed by the
[Setup] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “2. Speaker
Setup,” and then press the
[Enter] button.
3
Use the Up and Down [ ]/[ ]
buttons to select “Eq Settings,”
and then press [Enter].
4
Use the Left and Right [ ]/[ ]
buttons to select:
Off: Tone off, response flat.
Manual: You can adjust the equal-
izer for each speaker
manually.
If you selected Manual, continue with
this procedure. If you selected Off, go
to step 8.
5
Press the Down [ ] button, and
then use the Left and Right
[ ]/[ ] buttons to select a
speaker.
6
Use the Up and Down [ ]/[ ]
buttons to select a frequency.
Use the Left and Right [ ]/[ ]
buttons to adjust the level at that
frequency.
The volume at each frequency can be
adjusted from –6 to +6 dB in 1 dB
steps.
Tip: Low frequencies (e.g., 63Hz)
affect bass sounds; high frequencies
(e.g., 16000Hz) affect treble sounds.
7
Use the Up [ ] button to select
“Ch,” and then use the Left and
Right [ ]/[ ] buttons to select
another speaker.
Repeat steps 5 and 6 for each speaker.
Speakers that you’ve set to No or None
in the Speaker Configuration (page 35)
cannot be selected.
8
Press the [Setup] button.
The setup menu closes.
DTR-4.9_En.book Page 38 Tuesday, April 15, 2008 5:13 PM