Owner's Manual
39
First Time Setup
—Continued
If you connect a video component to an HDMI IN, you
must assign that input to an input selector. For example,
if you connect your DVD player to HDMI IN 1, you
must assign HDMI IN 1 to the DVD input selector.
By default, none of the HDMI inputs are assigned. The
following input selectors can be assigned: DVD,
VCR/DVR, CBL/SAT, Game/TV, Tape, CD.
Notes:
• Each HDMI IN cannot be assigned to more than one
input selector.
• When an HDMI IN is assigned to an input selector as
explained here, the digital audio input for that input
selector is automatically set to the same HDMI IN.
See “Digital Input Setup” on page 40.
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
HDMI Input Setup
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Input
Assign,” and then press [Enter].
3
Use the Up and Down [ ]/[ ]
buttons to select “1-1. HDMI,” and
then press [Enter].
Setup
Receiver
Enter
4
Use the Up and Down [ ]/[ ]
buttons to select an input selec-
tor, and use the Left and Right
[ ]/[ ] buttons to select:
HDMI1:
Select if the video compo-
nent is connected to HDMI
IN 1.
HDMI2:
Select if the video compo-
nent is connected to HDMI
IN 2.
HDMI3:
Select if the video compo-
nent is connected to HDMI
IN 3.
- - - - -:
Select if you’re not using the
HDMI IN1–IN3.
5
Press the [Setup] button.
Setup closes.
DTR-4.9_En.book Page 39 Tuesday, April 15, 2008 5:13 PM